Belkin Range Extender/ Access Point Manuel d'utilisateur Page 13

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 57
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 12
1110
Configuring the WURE
1110
Configuring the WURE
3.2 Click the Refresh button. The Utility will detect the
WURE(s) connected to your network. Select the WURE you
wish to configure.
3.3 If your WUREs IP address is not in the same subnet as your
network, the Set IP Address button will be enabled. Click
the Set IP Address button. A pop-up screen will appear.
3.4 Set the IP address of your WURE to be within the same sub-
net as your network. For example, if your routers IP address
is 192.168.1.1, set your WURE to 192.168.1.xx (xx would
be any number between 2254). Be careful of duplicate IP
addresses on your network. Then set the subnet mask to be
the same as your networks subnet mask.
3.5 Click the UR/AP button.
Wir eless Rang e Extend er
NOTE: If the UR/AP button is grayed out, click the
Refresh button.
Vue de la page 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 56 57

Commentaires sur ces manuels

Pas de commentaire