Belkin Range Extender/ Access Point Manuel d'utilisateur télécharger pdf (Page 11)

Configuring the WURE







Wireless G

Universal Range

Extender

Wireless G

Notebook Card

Wired Router

Wireless G

Desktop Card

Configuring as a Wireless Access Point

1. Connect

Connecting as a Wireless Access Point

The WURE can add wireless-enabled computers to an existing wired

network. The access point acts as a bridge between your existing

wired network and your wireless-equipped computers. Please be sure

to follow the steps below carefully.

1.1 Select a suitable place for your WURE.

1.2 Connect a CAT5 cable between the WURE and your router’s

LAN port, or an Ethernet switch or hub.

1.3 Connect the power supply to the WURE by plugging the

round DC connector into the DC jack on the WURE. Plug the

power supply into the wall. Verify that the “Power” LED and

the “LAN” LED are illuminated. If both LEDs are illuminated,

the WURE is connected properly.



















1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 56 57

Pas de commentaire

Belkin Range Extender/ Access Point Manuel d'utilisateur Page 11