Belkin SOHO KVM 2-Port Manuel d'utilisateur télécharger pdf (Page 23)

section

Firmware-Upgrade Guide

Connect your KVM Switch to the Mac Host

Step 5.

Press the first front-panel button on the KVM Switch until you hear two beeps.

Now the KVM Switch has entered into the upgrade mode.

Step 6.

Check to make sure the KVM cables from port 1 are connected to the

Mac host.

Note: A special upgrade cable is not needed to perform the upgrade since you can

use the same KVM cable that you use for connecting to the computers. However,

depending on the different models, the KVM cables you use

will vary.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 35 36

Pas de commentaire

Belkin SOHO KVM 2-Port Manuel d'utilisateur Page 23