Belkin OmniView F1DP116G Manuel d'utilisateur télécharger pdf (Page 30)

2626

Local Installation

Getting Started:

1. Make sure that all servers and Switches are powered off and that each KVM

Switch has been assigned a unique BANK address.

2. Place the SMB KVM-over-IP Switch and all secondary KVM Switches in the

desired location.

3. Connect the console monitor, keyboard, and mouse to the console ports

of the SMB KVM-over-IP Switch. Refer to “Connecting the Console to the

Switch” on page 14.

Connecting the Primary and Secondary KVM Switches:

1. Using the Daisy-Chain Cable (F1D108-CBL-XX), connect one end to the

“Daisy-Chain” port on the SMB KVM-over-IP Switch.

2. Connect the other end of the Daisy-Chain Cable to the “Primary Input/

Secondary Output” port of the first secondary KVM Switch (BANK 01).

3. To add secondary units, connect one end of the Daisy-Chain Cable to the

“Secondary Input” on the first secondary KVM Switch and the other end

to the “Primary Input/Secondary Output” port of the next secondary KVM

Switch (for example, BANK 01).

4. Repeat step 3 for additional KVM Switches you wish to add to your

daisy-chain configuration.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 83 84

Pas de commentaire

Belkin OmniView F1DP116G Manuel d'utilisateur Page 30