Belkin F6D3000 Manuel d'utilisateur télécharger pdf (Page 36)

Troubleshooting

section

If you are using a Belkin Dual-Band Wireless A+G Router in

802.11a mode, “Belkin Super A” is the default name.

If you are using a Belkin Dual-Band Wireless A+G Router in

802.11b/g mode, “Belkin Super G” is the default name.

If you are using a Belkin 802.11g (125HSM) Router, or Belkin

802.11g (54g) router, “Belkin54g” is the default name.

If you are using a Belkin 802.11b Router, the default name should

be “WLAN”.

If you are using a Belkin Pre-N Router, the default name should

be “Belkin pre-N” followed by the serial number specific to

that Router.

If you are NOT using a Belkin Router, please consult your router

manufacturer’s user manual for the default name.

The name of your wireless network appears in

“Available Networks”

If the correct network name is listed in “Available Networks”,

please follow the steps below to connect wirelessly:

1. Click on the correct network name in “Available Networks” to

connect to the network.

2. If the network has security (encryption) enabled, you will need

to enter the network key. For more information regarding

security, see the page entitled: “Configuring your Belkin

Wireless Card to Use Security” of this User Manual.

Within a few seconds, the tray icon in the lower right-hand

corner of your screen should turn green, indicating a

successful connection to the network.

If you are still unable to access the Internet after connecting to

the wireless network, please contact Belkin Technical Support.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 49 50

Pas de commentaire

Belkin F6D3000 Manuel d'utilisateur Page 36